51
TS 500i
:
Position cylinder (1) so that the
manifold (3) is facing the injection
valve (2)
When fitting the cylinder over the
piston, ensure that the clamping
strap securely encloses the piston
and that none of the piston rings
protrudes – danger of breakage.
:
Slide the cylinder (1) over the
piston; the clamping strap is
pushed downwards at the same
time
:
Remove clamping strap (1) and
wooden assembly block (2)
Ensure that the cylinder gasket is
correctly positioned.
:
Push the hose clip (3) onto the
manifold so that the screw head
is facing the clutch
1
1307RA107 TG
2
3
1307RA108 TG
3
1
2
– Push cylinder as far as possible
over the centering sleeves and
hold
For the pan head screw in the
hose (2), the tool is guided through
the hose to screw in the pan head
screw.
:
Screw in all pan head screws (1)
from the bottom – do not tighten
– Check the position of the cylinder
gasket
:
Tighten all pan head screws (1)
crosswise
:
Push the manifold (1) completely
and evenly onto the
supports (arrow) of the tank
housing until it is in the groove on
the circumference
– Push the hose clip over the
shoulder of the manifold
1307RA368 TG
1
1
2
1
1307RA236 TG
1
:
Align the hose clip (1) on the
manifold (3) so that the clamping
gap lines up with the fin (arrow)
:
Screw in the screw (2) and
tighten it
– Reassemble remaining parts in
reverse order
1307RA237 TG
1
2
3
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
