77
TS 500i
8.
Starter
8.1
General
If the action of the starter rope
becomes very stiff and the rope
rewinds very slowly or not
completely, it may be assumed that
the starter mechanism is in order
but plugged with dirt. At very low
outside temperatures, the
lubricating oil on the rewind spring
may thicken and cause the spring
windings to stick together. This has
a detrimental effect on the function
of the starter mechanism.
To clean the rewind spring, it is
sufficient to apply a few drops of a
standard solvent-based degreasant
not containing any chlorinated or
halogenated hydrocarbons to the
rewind spring.
Carefully pull out the starter rope
several times and allow it to rewind
until its normal smooth action is
restored.
Before installing, lubricate the
rewind spring and starter post with
STIHL special lubricant.
If clogged with dirt or pitch, the
entire starter mechanism, including
the rewind spring, must be removed
and disassembled. Take particular
care when removing the spring.
– Clean all parts,
8.2
Removal and installation
:
Take out the collar nuts (arrows).
:
Remove starter (1)
– Reassemble parts in reverse
order
370RA010 TG
370RA218 TG
1
8.3
Pawl
– Remove starter,
:
Carefully ease the spring (1) off
the starter post
:
Pull out the pawl (1)
Installation
:
Slide a new pawl into the hole
(arrow) and grease the peg (1),
370RA219 TG
1
1
370RA220 TG
1
370RA221 TG
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
