82
TS 500i
Washer (1) must be fitted.
:
Align spring housing (2) with
replacement spring so that it lines
up with the mounts (arrow)
:
Press spring housing (1) as far as
it will go into the mount of the
starter cover
:
Insert and tighten the screws (2)
– Install the pawl,
– Grease the pegs on the pawl,
– Tension the rewind spring,
– Reassemble remaining parts in
reverse order
1307RA048 TG
2
1
1307RA049 TG
1
2
2
If the rewind spring pops out
during installation, fit it in the
spring housing as follows:
:
Arrange the spring (1) as shown
in the illustration
:
Position the spring loop in the
fixture (arrow) in the spring
housing
:
Fit the rewind spring (1)
completely in a circular fashion,
working in clockwise direction
– Secure the spring so that it
cannot pop out
– Push spring housing as far as it
will go into the mount of the
starter cover
1307RA318 TG
1
1307RA319 TG
1
– Secure the rewind spring so that
it cannot pop out
:
If necessary, align the inner
spring loop (arrow) with suitable
pliers so that it rests against the
starter post at a slight angle
– Install the rope rotor,
– Install the pawl,
– Grease the pegs on the pawl,
– Tension the rewind spring,
– Reassemble remaining parts in
reverse order
1307RA320 TG
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
