95
TS 500i
:
Position the manifold (1) so that
the lug (arrow) lines up with the
throttle shutter housing (2)
:
Insert screws (3)
– Manifold is secured to the
throttle shutter housing
:
Push the new gasket (1) on the
opposite side of the throttle
shutter housing (2) over the
screws
:
Align the screws (1) so that they
only protrude slightly on the
throttle shutter housing (2)
1307RA156 TG
1
3
3
2
1307RA157 TG
1
2
1307RA158 TG
2
1
1
:
Fit throttle shutter housing (1)
with gasket and manifold (2) and
insert screws (3)
– Check and adjust the position of
the gasket if necessary
:
Insert and tighten the screws (3)
:
Push the hose clip (1) onto the
manifold (2) so that the screw
head is on the clutch side
:
Slide the hose clip (1) over
the shoulder (arrow)
– only push the hose clip onto the
shoulder once the tank housing is
installed
Apply STIHL press fluid to the inside
of the manifold
– Install the handlebar,
– Install the control unit,
1307RA159 TG
2
3
1
3
1307RA160 TG
1
2
– Fit the shroud,
– Check correct functioning
– the throttle cable must move
easily and when the throttle
trigger is in the full throttle
position, the throttle shutter must
be open all the way
– Reassemble remaining parts in
reverse order
11.2.1 Air baffle / throttle cable
– Remove shroud,
– Remove control unit,
:
Unhook the throttle cable (1)
from the mount (arrow)
:
Raise the retaining tab (2) slightly
and pull out air baffle (3)
1307RA161 TG
1
2
3
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
