33
TS 500i
:
Position the grooved ball
bearing (2) with press arbor (1)
4224 893 7200 and press it as far
as possible against the circlip
Do not press too hard, otherwise the
circlip which has been fitted as a
stop will be jammed.
– Take out the press arbor
– Fit the second circlip in the
groove in the cast arm
The seal on the deep groove ball
bearing must not be damaged.
– Fit the guard on the cast arm,
– Fit the "cast arm with guard",
370RA030 TG
1
2
4.3
Testing radial and axial
truth of running
Since the radial truth of running of
the cutting wheel changes if the
shaft diameter changes (due to
scoring, etc.), it is sufficient to
carefully inspect the shaft around
the mount for the cutting wheel.
The axial truth of running, on the
other hand, depends on the
condition of several parts and
should therefore be determined by
measurement.
– Undo the screw and remove the
thrust washer, see
:
Position test wheel (1)
5910 851 6100
:
Fit the thrust washer so that the
lugs (1) engage the grooves
(arrows) in the shaft
370RA045 TG
1
370RA039 TG
1
1
– Insert and tighten the screw
:
Secure a dial gauge holder (1)
5910 850 6000 with fitted dial
gauge (2) 0000 890 9100 on the
guard so that the axial truth of
running can be determined for a
diameter of approx. 130 mm over
one full revolution of the wheel,
see test table.
– Remove the test equipment after
testing.
370RA047 TG
2
1
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
