48
TS 500i
:
First slide the pegs (arrows) on
the cap (1) into the mount, then
press it home
– Insert and tighten the screw
:
Push the plug (1) into the socket
on the control unit until it snaps
into place
– Fit cover
6.5
Engine
Removal
– Remove the "cast arm with
guard",
– Empty the fuel tank,
– Remove shroud,
– Remove control unit,
– Remove handlebar,
– Remove tank housing,
370RA116 TG
1
1307RA189 TG
1
To remove the engine, you do not
need to disconnect the fuel hoses.
:
Remove hose clip (1)
Installation
:
Push the hose clip (1) onto the
manifold (2) so that the screw
head is facing the clutch
– Apply press fluid to the inside of
the manifold,
– Install the tank housing,
– Reassemble remaining parts in
reverse order
1307RA088 TG
1
1307RA089 TG
1
2
6.6
Cylinder
Before removing the cylinder,
decide whether or not the
crankshaft is to be removed.
With the cylinder in place:
The piston must be blocked to
prevent the crankshaft turning in
order to remove the clutch,
With the cylinder removed:
To dismantle the clutch, block the
crankshaft by placing the piston on
the wooden assembly block.
– Remove the "cast arm with
guard",
– Empty the fuel tank,
– Remove shroud,
– Remove control unit,
– Remove air baffle,
:
Loosen the screw and push the
hose clip (1) in the direction of the
throttle shutter housing
:
Push down the manifold (2) from
the tank housing support
1307RA224 TG
1
2
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
