79
TS 500i
:
Fit the rotor on the starter post so
that the inner loop of the
spring (1) enters the recess
(arrow).
The recess (arrow) in the hub of the
rope rotor acts as carrier for the
anchor loop.
– Fit the washer.
– Install the pawl and spring,
– Install starter rope,
– Tension the rewind spring,
– Grease the pegs on the pawl,
– Reassemble remaining parts in
reverse order
8.5
Starter rope / starter grip
– Remove starter,
– Relieve the tension of the rewind
spring,
The rewind spring will not be under
tension if the starter rope is broken.
– Remove any remaining scraps of
rope from the rope rotor and
starter grip.
1307RA039 TG
1
The starter rope must not be
shortened.
– Remove the rope rotor,
:
Pull out starter rope (1) on the
rope rotor (2) and undo the knot
– Pull starter rope from rope rotor
and starter cover
:
Pry the nipple on the rope (1) out
with a suitable tool
1307RA040 TG
1
2
1
370RA229 TG
:
Pull the rope (1) or remaining
rope out of the starter grip,
examine the various parts,
replace if necessary.
– Remove any remaining rope from
the rope rotor if necessary
:
Thread the new starter rope (1)
into the starter grip from above
:
Press the nipple (1) of the starter
rope into the starter grip until it
engages there
370RA230 TG
1
370RA231 TG
1
370RA232 TG
1
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
