87
TS 500i
:
Position the handlebar (1) over
the machine and push into the
mounts (arrows)
Bearing plug (1) must be twisted
into the antivibration spring as far as
it will go.
:
Push the bearing plug (1) into the
mount (arrow) and hold it in
position
:
Screw in the screw (1) and
tighten it
1307RA335 TG
1
1307RA336 TG
1
1307RA326 TG
1
– Mount the support,
:
Fit the clamp (1) so that the peg
engages in the hole (arrow). This
secures the antivibration spring
in the handlebar.
– Coat inside of hose with STIHL
press fluid,
:
Fit clamp (1), the peg must
engage in the hose (arrow)
:
Insert and tighten the screws (2)
:
Insert and tighten the long
screw (3)
370RA276 TG
1
1307RA337 TG
2
3
2
1
:
Fit the clamp (1) on the opposite
side so that the guide (arrow) is
on the inside of the handlebar
:
Insert screw (2) through the
clamp and handlebar, and screw
it tightly into the opposite
clamp (3)
9.6
Rubber buffers / support
9.6.1
Support
:
Remove screws (1) and (2)
1307RA035 TG
2
3
1
1307RA338 TG
2
1
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
