Check the belt tension
–
Lower indicator arm (1)into the measuring
device.
–
Place guide (3)between two belt pulleys on
the V-belt (2). The stop must be at the side.
–
Press the button (4)at right angles to the V-
belt (2)evenly until you hear or feel the
spring snap in.
–
Lift the measuring device carefully without
altering the position of the indicator arm
(1)).
–
Read the measured value at the point of in-
tersection (arrow), scale (5)and indicator
arm (1).
–
Retighten and repeat the measurement if
necessary.
Changing the hydraulic transmis-
sion crude oil filter
ENVIRONMENT NOTE
Please follow the instructions for disposal of
fluids and lubricants.
NOTE
Place a container under the crude oil filter to
collect oil flowing out of the transmission.
–
Remove the floorplate.
–
Unscrew the fastening screws and washers
on the crude oil filter.
–
Slowly pull out the crude oil filter so that the
oil flows into the container.
–
Unscrew the crude oil filter from the oil filter
seat.
Maintenance
5
Maintenance service
140
60048011601 EN - 08/2020
Summary of Contents for RCG15
