Maintenance
6
Maintenance
CAUTION
Risk of component damage!
If you remove the battery male connector when the
key switch is switched on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens their service life.
– Switch off the key switch before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
DANGER
Risk of fire!
Using the wrong fuses can result in
short circuits.
– Only use fuses with the prescribed
nominal current.
NOTE
Depending on the equipment, not all fuses will
be present in the truck.
6210_604-001
1
Fuses for standard equipment and equipment
variants are located in the rear part of the
control electronics (1).
– Open the cover.
– Remove the cover from the control electron-
ics.
– Replace the blown fuse; see the section
entitled "Fuse assignment".
CAUTION
Water in the electrical system can
cause damage to components!
In order to protect the electrical
system against ingress of water, the
cover must be closed.
– Refit the cover after these tasks
have been completed.
– Connect the battery male connector.
– Carry out a functional test.
170525 EN - 10/2016
363
Summary of Contents for RX60-16
