Operation with reversible fork
arms (variant)
DANGER
Risk to life from falling load!
Standard fork arms are not structurally designed for
reverse operation. If this instruction is not observed,
it can lead to material failure and the load falling.
–
Only work in reverse operation using reversible
fork arms (1)
WARNING
Risk of accident from slipping load!
Loads may slip on the reversible fork arms if there is
no load support. A fork extension (variant) cannot be
secured against slipping.
–
Do not use a fork extension (variant)
WARNING
Risk of accident from the truck tipping over.
When driving, the centre of gravity of the load (2)
must not be higher than 600 mm above the ground.
The truck may tip forwards when driving or braking.
–
Only drive with a load centre of gravity up to a
max. of 600 mm above the ground
NOTE
If the truck is equipped with the "load meas-
urement" comfort feature, a "zero adjustment
of the load measurement" must always be
performed after the reversible fork arms have
been changed. Otherwise, correct load meas-
urement cannot be guaranteed.
Operating
4
Lifting
170
56358042501 EN - - 11
Summary of Contents for RX60-60
