After determining the location for your KS-Series Subwoofer Enclosure by trial fitting,
find the best placement for the mounting brackets. Each bracket must be positioned so
that the rounded end protrudes from under the cabinets firmly to the vehicle (See
Diagram 2). In a truck application the KS-Series Enclosure can mount with the flat side
towards the back of the cab to allow room for two brackets on the top edge and one
bracket on each end.
DIAGRAM 2
If the enclosed brackets are not applicable to your installation, some other means must
be utilized to secure the speakers to the vehicle.
For optimum sound quality the KICKER KS-Series Enclosure should be used with some
form of low pass crossover. This can be a passive crossover (such as the KICKER SW100) or
and electronic crossover used before a dedicated subwoofer amplifier.
When wiring the Substations to your amplifier, connect the positive output from one
channel to the red input terminal of one speaker, then connect the negative output from
that channel to the black input terminal of the speaker. Repeat this procedure for the
other Substation.
The wiring configuration can vary depending on the impedance capability of your
source. For wiring suggestions other than those described above, please consult the
manufacturer of your amplifier.
SPECIFICATIONS
Model
KS60
KS80
Frequency Response
32-1kHz
29-1kHz
Maximum Amplifier Power*
100 watts RMS
150 watts RMS
Impedance
4 Ohms
4 Ohms
*Assumes typical music program with minimal amplifier clipping.
All manuals and user guides at all-guides.com