10
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: GYJ45-68 PRODUCT CODE: 52533 05/2016
Unpacking
•
This product has been packaged to protect it against transportation damage. When
unpacking keep all packaging until you have made sure your new clothes dryer is
undamaged and in good working order. The carton is recyclable. Whenever possible,
reuse the carton and recycle it when disposing of the packaging materials.
•
Plastic wrapping can be a suffocation hazard for babies and young children, so ensure
all packaging materials are out of their reach. Dispose of packaging safely.
•
Make sure to remove the transport packaging at the rear of the clothes dryer.
•
Inspect the cord and plug for damage or wear before each use. Do not use the
appliance if the appliance or its cord have been damaged or are not working properly.
In case of damage, contact our after sales support line.
•
Read all instructions in this manual and make sure you understand all warnings.
•
Wipe the inside of the drum with a damp cloth to remove any dust from transport.
Important notes regarding installation
•
This clothes dryer can be installed on the floor level (as supplied, or upside down with
the control panel at the top), or wall-mounted (as supplied). Detailed instructions for
each option are provided on the following pages.
•
The appliance must not be installed behind a lockable door, sliding door or a door with
a hinge on the opposite side of the clothes dryer, in such a way that a full opening of
the tumble dryer door is restricted.
•
Do not install the appliance in a tight fitting cabinet.
•
Make sure that all electrical connections are made by qualified personnel and all
instructions in this manual as well as local safety regulations are observed.
•
Place the dryer in a dry, well ventilated area, away from heat and direct sunlight.
•
Exhaust air must not be discharged into a flue which is used for exhausting fumes
from appliances burning gas or other fuels.
Floor level installation
•
If the dryer is installed on the floor, make sure to place it on a firm, flat, dry and stable
floor, close to an appropriate wall outlet. Do not place it on soft material such as foam,
plastic or carpet, as this will block the air intake.
•
The dryer comes with legs to ensure stability. If you are
installing the appliance with the control panel at the
top), you will need to reassemble the legs on the bottom
panel. To avoid damaging the floor, lay the dryer on a
large piece of cardboard (from the dryer carton) and
attach the legs as illustrated (Fig. 1).
•
See points 3 and 4 on page 13 for installation of the exhaust connector.
•
Stand the dryer on its feet and slide it into position, leaving a space of at least 10cm
between the dryer and any wall. All four legs are adjustable; just turn them to assist in
levelling the dryer, if necessary. When the dryer is level, tighten the legs.
Getting Started: Installation
CAUTION:
This appliance is heavy. Use two or more people to move and install it.
Fig. 1
