After Sales Support
Telephone:
1300 886 649
Email:
info@tempoaustralia.com.au
10
Cord release and rewind
• Holding the power plug firmly, pull it to fully
unwind the cord (Fig. 7). A yellow mark on
the cord indicates the recommended cord
length. Do not pull out the cord past the red
mark. Position the cord so no one is likely
to trip over it.
• To rewind the power cord, press the cord
retraction pedal (Fig. 7).
CAUTION:
Take care, the cord retracts very
quickly. Guide it with one hand to prevent
the cord from whipping, which could cause
damage or injury.
Switching on and off
• Insert the plug into a power point and
press down the On/Off pedal to switch the
vacuum cleaner on (Fig. 8).
• Press the pedal again to turn the vacuum
cleaner off.
Carpet and hard floor cleaning
• For carpet and rug cleaning, press the
rocker switch on the dual use floor brush to
raise the bristles (Fig. 9).
• When the bristles are raised, press the
rocker switch to lower the bristles for
vacuuming floor boards, tiles or other hard
floor coverings (Fig. 9).
• Pull the vacuum cleaner behind you on its
wheels. Hold the extension tube by the
handle and gently slide the floor tool over
the surfaces to be vacuumed.
Instructions
Fig. 8
Fig. 7
Fig. 9
WARNING!
Check the vacuum cleaner and power cord before each use.
Do not use the appliance if any part is damaged.
