Page 7
When the LED is flashing, there is traffic on the network to
which the 10Gbase-T network card is connected
Link Speed Indicator:
When the LED is lit orange, a 10GBase-T link is established
When the LED is lit green, a 1000Base-T link is established
When the LED is off, a 100Base-T link is established
2.2 Hardware Installation
1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer’s cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the card, carefully align the card’s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly. This card works in PCI Express slots of additional lanes
(x4, x8 or x16 slots)
5.
Replace the slot bracket’s holding screw to secure the card.
6.
Secure the computer cover and reconnect the power cord.
