STM Instruments Inc Page 2
Installing the Battery
1.
Turn the
eDrometer
over such that the bottom of
the base (1) is exposed.
2.
Locate the battery cover (5); depress the latch of the
battery cover until the cover can be removed.
CAUTION: DO NOT DEPRESS THE LATCH SUCH THAT
IT WILL CAUSE PERMANENT DAMAGE AND
PREVENT THE COVER FROM WORKING PROPERLY.
3.
Once the battery cover (5) is removed the battery
cable (6) will be exposed.
4.
The
eDrometer
is powered by a 9 volt battery;
connect the battery to the battery cable (6).
5.
Place the battery and battery cable (6) in the battery
compartment. The battery should lay flat.
6.
Insert the tongue of the battery cover (5) into the
compartment slot, close the cover until the latch
engages and secures the battery.
CAUTION: IF THE
BATTERY COVER DOES NOT EASILY CLOSE, THERE
MAY BE AN OBSTRUCTION, OR THE BATTERY IS NOT
ORIENTED CORRECTLY. DO NOT FORCE CLOSURE.
THIS MAY DAMAGE THE BATTERY COVER.
7.
Once the battery cover is secure the
eDrometer
is
ready for operation.
Using the Power Adaptor (Purchased Separately)
1.
Locate the power plug on the side of the
eDrometer
2.
Plug the power adapter into the power plug, and
then plug the other end of the adapter into a 120
volt wall socket.
CAUTION: PLEASE MAKE SURE YOU
ARE NOT IN CONTACT WITH ANY CONDUCTIVE
FLUID (i.e. WATER) THIS COULD LEAD TO AN
ELECTRICAL SHOCK.
Summary of Contents for eDrometer
Page 4: ...STM Instruments Inc Page iv Notes...
Page 30: ...STM Instruments Inc Page 23 Notes...
Page 31: ...STM Instruments Inc Page 24...
