Warning: Please read directions completely before starting. If you have any
questions, please contact BMPP before beginning your installation. Also, please
check our website (www.stonsho.com
)
for any updates or changes. Thank You.
Parts Included:
License Plate mounting bracket Assembly. Includes Base Plate and
License Plate Holder.
License Plate Mounting Screws: (2) 6mm X 12mm (Phillips head), (2)
6mm nuts (10mm wrench size)
Base plate mounting screws: (1) 4.2mm X 55mm screw with 4mm washer
(1) 6.3mm X 20mm with washer (1) nylon
1 ¼”
spacer.
Tools Needed:
7mm T15 Torx & 10mm sockets with ratchet Note: 1/4-inch drive
preferred but 3/8 will work (but extra caution will be needed when
tightening screws)
Phillips screwdriver & 10mm wrench
1/8-inch drill bit and drill.
Step 1: Ensure all parts listed above are accounted for. Note: If at any time during the
installation process you need assistance please call (408) 776-4080.
Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring
outward and sliding apart.
Step 3: Remove center spoiler screw (4.2mm) using a 7mm socket as shown in figure 1.
Step 4: Now position the base mount with the small hole towards the front of the car, centered
over the hole where the 4.2mm screw was just removed. Note: Tube will be facing down.
Using the (1) 4.2mm X 55mm screw, 4mm washer and the (1)
1 ¼”
nylon spacer secure the base
plate in place. See figure 2
Step 5: Once the base plate is secured using the front mounting hole, slide the front bracket
into the tubes to verify alignment. Remove when alignment is complete and carefully drill pilot
hole for the rear mounting screw. See figure3.
Step 6: Using the 6.3mm X 20mm screw secure the rear of base plate to the vehicle using the
following method. Caution: When tightening the screw extreme care should be taken not to
over tighten screw or the hole may become stripped and lose its ability to secure the base
