Pan
Tilt
Accessories
Circlip
MODULE AND ACCESSORIES
The fitting uses a Xicato XIM LED module. The colour
temperature and lumen output can be found on the
product label on the fitting.
To add/remove accessories:
Isolate the fitting from the supply and allow to cool.
Step 1 To remove optic and accessories remove circlip.
Step 2 Replace optic/accessories as required and
replace circlip to secure.
ADJUSTMENT
To adjust the tilt and pan of the fitting use the supplied
2.5mm Allen key to loosen off the tilt and pan lock screws.
Once the desired angle is achieved lock off the screws.
DO NOT
over tighten the screws as this could damage
the lock and cause it to no longer function.
Optic
STX2.50 Integral.pdf 4 03/12/2020 09:37:59
