Stockmaster Lift-Truk, Assembly Instructions Manual

2 Piece Mast Assembly

2 Piece Mast Assembly

Illustration 1

Illustration 2

Illustration 3

Illustration 4

M6 x 16

M6 x 16

IMPORTANT

: 

To avoid assembly problems follow these instructions exactly. Work Safely 

Instructions for sizes with 12 to 14 steps including the platform:

Step 1 

- 

On a level surface butt the two Mast sections together. (See illustration No. 1)

Step 2

 - 

Fix the Large Mast Joining Plate to the two Mast sections using four of the M6 x 16 button head screws - 

Finger tight only. 

(See illustration No. 2)

Step 3

 - 

Turn the Mast over. Locate the Small Mast Joining Plates and position them inside the Mast channel and 

fasten using four of the M6 x 16 button head screws. Ensure Mast sections are correctly aligned and then tighten all 
screws.

 (See illustration No. 3)

Step 4

 -

  Lift the Mast as shown cut and remove the Wire Tie then lay the Mast flat on its back again. (See illustration 

No. 4) 

Step 5 

-

 In the centre of the Mast Channel. Cut and remove the 

Black Wire Ties

 holding the chain bundle in position.  

(See illustration No. 5)

Note: 

Do 

NOT

 cut the 

White Wire Tie

.

Step 6 

-

 Using the White Wire Tie. Pull the stored chain down the length of the mast untill taught. (See illustration 

No. 6)

Step 7 

- 

Loosen the Mast Roller at the base of the Mast (See illustration No. 7) 

Step 8 

- 

Using the 2 Black Wire Ties supplied. Tie the chain to the top of the Mast thru the holes A & B. Ensure the 

White Wire Tie is located between these two tie positions. (See illustration No. 8) 

23

24