Stockmaster Lift-Truk, Assembly Instructions Manual

Ladder Frame Assembly

Ladder Frame Assembly

Illustration 1

Illustration 2

Illustration 3

Illustration 4

Flat Brace

M10 x 20

IMPORTANT

: 

To avoid assembly problems follow these instructions exactly. Work Safely - Do not stand the 

frames upright when assembling. Place the frames in the positions as shown in the illustrations.

Step 1 

-

 Lay the Rear Frame (without steps) on the floor. Check that the Flat Brace is at the floor level. If not, turn 

the frame over. Place the Platform over the frame as shown. (See illustration No. 1)

Step 2 

-

 Place one of the two Tube Braces under the Platform Safety Rail. (See illustration No. 2)

Step 3

 -

 Fix the other Tube Brace, Platform and Rear Frame together using a 10 x 20mm bolt and nut. 

Finger tight 

only

. For ease, lift the Frame up slightly. Remove the Tube Brace from under the Platform Safety Rail and fit to the other 

side. (See illustration No. 3)

Step 4

 -

 Turn the Platform on its side, the Rear Frame will stand up. Place something under the Platform Rails as 

illustrated so the centre line of the Rear Frame is approximately parallel to the floor. (The long box may be used for this). 
(See illustration No. 4)

Step 5

 -

 Engage the Front Frame (with steps) into the Platform and fix together using a 10 x 20mm bolt and nut. 

Finger tight only

. For ease, lift the Frame up slightly. Repeat this step for the other side. (See illustration No. 5)

Step 6

 -

 Fix the free ends of the Tube Braces to the Front Frame using 10 x 20mm bolts and nuts -

Finger tight only

. 

Do not tighten the 10mm bolts untill advised. 

(See illustration No. 6)

9

10