IMPORTANT
:
To avoid assembly problems follow these instructions exactly.
Step 1
-
Cut and remove the
Black Wire Ties
at the top of the Mast. Do not cut the Large White Centre Tie
(See illustration No. 1)
Step 2
-
Position the Chain around the Sprocket using the Large White Wire Tie. Once the Chain is engaged correctly,
cut and remove the Wire Tie. (See illustration No. 2)
Step 3
-
Slide the Chain Roller toward the bottom of the Mast to tension the Chain. Check that the Chain is engaged
with the roller and tighten the screw and nut. (See illustration No. 3)
Chain Setting
Illustration 1
Illustration 2
Illustration 3
29
30
NEXT:
Proceed to Mast Assembly.
31
