IMPORTANT
:
To avoid assembly problems follow these instructions exactly.
Step 1
-
Fasten the Angle Rotating Bracket to the Lower Side Safety Rail at A and B using two M6 x 40mm Bolts and
Nyloc Nuts -
Finger tight only
. (See illustration No. 1)
Step 2
-
Attach the Nylon Catch Plate to the inside
of the Rear Safety Rail with two M6 x 50mm
Bolts, Washers and
Nyloc Nuts at C and D -
Finger tight only
. (See illustration No. 2)
Step 3
-
Close the Rotating Side Safety Rail as shown. Twist the Locking Knob 1/4 turn so the pin is fully extended
and locate the pin in the Stricker Plate at E.. Tighten all bolts at A thru D untill
firm only.
(See illustration No. 3)
Step 4
-
Open and close the gate thru its full range ensuring it latches closed correctly. The holes in the Catch
plate are elongated for fine adjustement. When all is correct tighten all fixings using the hex key and spanner provided.
(See illustration No. 4)
Rota-Gate Assembly
Illustration 1
Illustration 2
Illustration 3
Illustration 4
M6 x 50
B
A
E
M6 x 40
M6 x 40
C
D
C
D
E
5
6
NEXT:
Proceed to Auto-Safe Gate Assembly.
7
