Stockmaster Step-Thru, Assembly Instructions Manual

6

www.stockmastereurope.nl

Tube Brace Assembly

IMPORTANT

: 

To avoid assembly problems follow these instructions exactly. Work Safely - Do not stand the 

frames upright when assembling. Place the frames in the positions as shown in the illustrations.

Instructions for sizes with 3 to 7 steps including the platform

:

There are no additional Tube Braces to be fitted to these sizes. Proceed to Control Handle Assembly

Instructions for sizes with 8 to 10 steps including the platform:

See Steps 1 & 2 only

Step 1 

- 

Place the Ladder on its side and place something under the Platform as illustrated so the centre line of the 

Rear Frame is approximately parrallel to the floor. The Mobilisation carton may be used for this. (See illustration No. 1)

Step 2

 - 

Remove the 4 off, M10 x 20 bolts and nuts from the Tube Braces packaged within the framset and 

Discard 

these Tube Braces

. (See illustration No. 2).

Note: 

The correct length Tube Braces for sizes 8 to 10 are packaged in the Mobilsiation carton. Open this carton 

and retrieve these parts now.

Step 3

 - 

Fix one of the two Tube Braces to the Frame at A and B using the M10 x 20 bolts and nuts from step 2 

above. Turn the Ladder over and fit the other Brace. - 

Finger tight only

. 

Do not tighten the M10 bolts until advised.  

(See 

illustration No. 3).