Page 11
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
5.2 Replacing Heat Lamp Bulbs
• Bulbs should be allowed to cool for 10 - 15 minutes before removing
• All heat lamp fi ttings are spring loaded for easy replacement
• Heat lamp bulbs should only be replaced with gloves or a soft cloth. No skin should touch the new bulb. If skin touches the new bulb,
wipe the bulb with a soft cloth and rubbing alcohol to remove all possible oils
1. Isolate from the power supply
2. Take off the end capping by removing the retaining screw (do not discard)
3. Slide out the four lamp shield bars
4. Holding the old bulb with a soft cloth or glove, press into one of the sockets, rotate out and remove
5. Holding the new bulb with a soft cloth or glove, press into one of the sockets, rotate in and slowly release the bulb into the other socket,
ensuring that the bulb does NOT become broken
6. Re-install the lamp shield bars then place the end capping into position and secure with the retaining screw
Retaining Screw
End Capping
Bulb
Socket
Lamp Shield Bars
5.0 Cleaning and Maintenance
5.1.6 Hot Food Display
1. Isolate the unit from the power supply
2. Remove the GN pans and three water wells. Wash separately in a dishwasher or kitchen sink, thoroughly wipe dry after cleaning
3. Clean using a clean cloth dampened (not wet) with clean warm soapy water until all soil has been removed
4. Thoroughly wipe dry with a soft cloth after cleaning, do NOT allow to air dry. Do NOT let water pool, check crevices and folds
5. Re-install the GN pans and three water wells
5.1.7 External Surfaces
1. Using a clean cloth dampened (not wet) with clean warm soapy water until any grime has been removed
2. Using a clean sanitised cloth, thoroughly wipe the stainless steel and metal parts dry. Do NOT let water pool on the unit. Check crevices
and folds
1. Clean the glass with a glass cleaner or warm (not hot) soapy water, and a sponge
2. Using a squeegee, remove all water from the glass
5.1.8 Display Glass