Owner’s Manual #513613
7
E112/F112 Model Machines
SECTION 3
INITIAL SET-UP AND OPERATION
3.1 OPERATOR’S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A.
Know the machine. Read and understand the
Operating Instructions.
B.
Notice all warning labels on the machine.
C.
Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D.
Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E.
Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F.
Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G.
Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine.
A. Spigot
Switch
The spigot switch will automatically start the auger
drive and refrigeration systems when the spigot
is opened to dispense product. When the spigot
is closed, the drive motor and compressor will
remain on until the product in the freezing cylinder
reaches the proper consistency..
WARNING
High voltage will shock, burn or cause death. The
OFF-ON switch must be placed in the OFF position
prior to disassembling for cleaning or servicing. Do
not operate machine with cabinet panels removed.
Figure 3-1 Controls
Consistency
Adjustment
Screw
Diagnostic
Light
Add Mix
Indicator
Clean/Off/On
Switch
