11
3.6 REMOVING MIX FROM THE FREEZER
To remove the mix from the freezer, refer to the following
steps:
A. Remove the mix inlet regulator from the hopper by
pulling straight up (Fig.16).
B. Place the OFF-ON rocker switch in the ON position
and push the CLEAN switch to rotate the auger.
Allow the mix to agitate in the freezer barrel until the
mix has become a liquid, about 5 minutes.
Figure 18. Auger Flight Wear and Front Auger
Support Bushing Wear
D. Place the OFF-ON switch in the OFF position.
3.7 CLEANING THE FREEZER
NOTE
The frequency of cleaning the freezer and freezer
parts must comply with local health regulations.
Figure 16. Removing Mix Inlet Regulator
C. Drain the liquid mix by opening the spigot. A bucket
or container should be placed under the spigot to
catch the liquid mix (Fig. 17).
Figure 17. Draining Mix
After the mix has been removed from the freezer, the
freezer must be cleaned. To clean the freezer, refer to the
following steps:
A. Close the spigot and fill the hopper with 2 gallons
(7.5 liters) of cold tap water.
B. Place the OFF-ON switch in the ON position while
pushing the CLEAN switch to rotate the auger.
C. Allow the water to agitate for approximately five
minutes.
NOTE
If freezer is left in CLEAN for more than 30
minutes, it will go to error.
D. Open the spigot to drain the water. Remember to
place a bucket or container under the spigot to catch
the water. When the water has drained, turn the
OFF-ON switch to the OFF position. Allow the freezer
barrel to drain completely.
E. Repeat steps A through D using a mild detergent
solution.
3.8 DISASSEMBLY OF FREEZER PARTS
CAUTION
PLACE THE OFF-ON TOGGLE SWITCH IN THE OFF
POSITION BEFORE DISASSEMBLING FOR CLEANING
OR SERVICING.
Inspection for worn or broken parts should be made at
every disassembly of the freezer for cleaning or other
purposes. All worn or broken parts should be replaced to
ensure safety to both the operator and the customer and
to maintain good freezer performance and a quality
product. Two normal wear areas are the auger flights and
front auger support bushing (Fig. 18). Frequency of
cleaning must comply with the local health regulations.
Summary of Contents for E131G
