Stoelting E131I, Owner'S Manual

14

NOTE

Clean the auger drive socket located inside the

barrel at the rear seal area. Use  clean cloth or

paper towel for this purpose.

D. Clean the drip trays and insert with a soap solution.

Rinse with clean hot water.

3.10 SANITIZE FREEZER AND FREEZER PARTS

A. Use a sanitizer mixed according to manufacturer’s

instructions to provide a 100 parts per million

strength solution. Mix sanitizer in quantities of no

less than 2 gallons (7.5 liters) of 120°F water. Allow

the sanitizer to contact the surfaces to be sanitized

for 5 minutes. Any sanitizer must be used only in

accordance with the manufacturer’s instructions.

B. Place all parts in the sanitizing solution, then remove

and let air dry.

C. Using this sanitizing solution and the large barrel

brush provided, sanitize the rear of the barrel and

drive area by dipping the brush in the sanitizing

solution and brushing the rear of the barrel.

3.11 ASSEMBLY OF FREEZER

To assemble the freezer parts, refer to the following

steps:

NOTE

Petrol-Gel sanitary lubricant or equivalent must

be used when lubrication of parts is specified.

NOTE

The United States Department of Agriculture and

Food and Drug Administration require that

lubricants used on food processing equipment

be certified for this use. Use lubricants only in

accordance with the manufacturer’s instruc-

tions.

A. Assemble all o-rings onto parts dry, 

without lubrica-

tion

. Then apply a thin film of sanitary lubrication to

exposed surfaces of the O-rings. Apply a thin film

of sanitary lubricant to metal part of rear seal. Also

apply a thin film of sanitary lubricant inside the hole

of the front of the auger.

B. Assemble the rear seals onto the augers with the

large end to the rear. Be sure the O-ring is in place

before installing the rear seal.

C. Lubricate the inside of the auger drive sockets (rear)

with a small amount of white socket lubricant. A

small container of socket lubricant is shipped with

the freezer.

D. Screw the springs onto the studs in plastic flights.

Springs must be screwed into the flights com

pletely

 to provide compression (Fig. 22).

CAUTION

Do not place the mix inlet regulator into the hopper

before installing the auger. Attempting to install the

auger with mix inlet regulator in place will damage the

mix inlet regulator.

E. Install the two plastic flights onto rear of the auger

and insert part way into freezer barrel.

F. Install the third plastic flight, push the auger into the

freezer barrel and rotate slowly until the auger

engages the drive socket.

Figure 22. Exploded View of Auger

3.9 CLEANING THE FREEZER PARTS

Place all loose parts in a pan or container and take to

the wash sink for cleaning. To clean freezer parts refer

to the following steps:

A. Place all parts in warm mild detergent water and

clean with brushes provided. Rinse all parts with

clean hot water.

B. Wash the hopper and freezer barrel with warm

detergent water and brushes provided.

C. Clean the rear seal surfaces from the inside of the

freezer barrel with warm detergent water.