14 - English
To ignite burners using match lighting:
Open the hood.
Turn all control knobs on the control panel
OFF ( O ).
Make sure the natural gas hose is tightly connected to
the natural gas supply line and a leak test has been per-
formed.
Using a match holder, place a match between the circular
wire.
Light the match and place into lighting hole on the side
of the firebox.
Push in the far right control knob and turn to
ON
.
When burner is lit, turn the control knob to the desired
setting.
If burner fails to light, extinguish the match then turn the
control knob off and wait five (5) minutes then repeat the
step.
NOTE:
Place burner on high and observe flame height
which should be approximately 1 in. If flame is too high
or too low, burner adjustment is required. See the
Main-
tenance
section later in this manual.
To light other burners: push in and turn on the control
knob next to the lit burner.
Refer to the grill’s operator’s manual for additional
safety and cooking tips.
MATCH
HOLDER
Fig. 25
OPERATION
LIGHTING
HOLE
Summary of Contents for SGA7040
Page 50: ...18 NOTES NOTAS ...
Page 51: ...18 NOTES NOTAS ...
