19
3.6 REX/REX F 400-600 CONTROL PANEL
The generators are equipped with electric board (IP 55 protection level), which are already assembled to the
different boiler accessories.
ELECTRONIC CONTROLLER
On the controller appear the water temperature in the boiler and can setting three values:
1. OP1 – ON/OFF burner;
2. OP2 – Second stage burner;
3. OP3 – Anticondensate pump.
To change the value:
OP1:
On main screen under the water temperature, can read the value of ON/OFF burner, to change
use the button
and
for increase o decrease, wait 2 seconds and the parameter will
be saved automatically.
OP2:
From the main screen push
and the parameter
A2S.P
is the value of the second stage
burner; change it with the arrows
and confirm with
.
OP3:
From the main screen push
and after
and the parameter
A3S.P
is the value of the
stop anticondensating pump; change it with the arrows
and confirm with
.
NB All the settings will have a fixed hysteresis of ICI BOILERS, above and below 1% of setting
the scale value of the temperature probe. (-99.9% - +300%).
Note: For more information, refer to the specific manual inside the electrical panel.
WIRING DIAGRAM
Refer to the diagram supplied with the specific switchboard.
Summary of Contents for REX F
