background image

 

Page 3

 

Accessories and spare parts: 

Only use accessories and spare parts which have been approved by the manufac-
turer. Original accessories and spare parts guarantee that the unit can be oper-
ated safely and without any breakdowns. 
 
Battery-operated units: 

Always comply with the operating instructions of the battery manufacturer. Observe 
the recommendations of the legislator when handling batteries. 
Never leave batteries in a discharged condition, but recharge them as soon as 
possible.  
Always keep the batteries clean and dry in order to avoid leakage current. Protect 

the batteries from contaminants, e.g. metal dust. 
Do not place any tools, etc. on the battery, otherwise there is a risk of short-
circuiting and explosion! 
Do not smoke, generate sparks or use naked flames near a battery or in a  charg-

ing area. Danger of explosion! 
Caution when handling battery acid. Comply with the corresponding safety regula-
tions. 
This machine is designed for operation in dry areas only. 

 

2. Technical Data: 

 
Sweeping width:  2 side brushes   

 

900 mm 

   1 

side 

brush 

  700 

mm 

 

 

 

without side brushes 

 

500 mm 

Working speed: 

up to 4.0 km/h 

Surface cleaning capacity with 2 side brooms 

3,600 m²/h 

Volume flow: 

200 m³/h 

Vacuum  

7 pa 

Filter surface: 

1.3 m³ 

Absorptive capacity of the sweeping vessel: 

60 l 

Allowable inclination: 

2% 

Length x width x height: 

1,000 780 x 460 mm  

 

(without steering han-

dle) 

Nominal voltage: 

12 V 

Nominal current: 

26 A 

Protection type: 

IP 20 

Weight: 

56 kg (with a 66 Ah 

battery) 

Sound level: 

67 dB (A) 

 
 

3.  Unpacking and Assembling 

Let the box stand on the pallet. Cut the front side open and let the machine roll 
over the side of the box which has been folded down (see Figure) so that the run-
ning wheels are still standing on the pallet.  
 

 
 
 
In this position, clip the side brushes which are on the dirt container under the side 
brush plate (in the front exterior portion of the machine) (see Figure). Apply light 

pressure to twist the brushes upwards until you can feel them lock into place. Note: 
do not tip over the machine in this process: there is the danger of battery acid 
running out.  

 

Summary of Contents for Tandem 900 KSE










Reviews: