Stone 65CMED, Operator'S Manual

- 16 -

OPERATION

SAMPLE MIX

Volume relationship of 1:2-1/4:3 (cement : sand :

gravel) mix.  The mix volume may vary depending on

aggregate used.

CLEANING

For consistent performance, long life and continued

high quality mixing of cement, thoroughly clean the

mixer inside and out at the end of each day's operation.

Drum may be scoured by 2 minute operation with

gravel and water mixture.  Discharge, then hose down

drum inside and out.  Keep mixer clean.

Before cleaning, shut off the engine or motor and

disconnect the spark plug wire or electric cord to

prevent accidental starting.  Spray the mixer with water

before the mix dries to remove any accumulations.

Dried mix should be scraped out as necessary.  DO

NOT beat on drum with shovel, hammer or other

device to break up accumulations of dried mix, as this

will dent and damage the drum.

NEVER POUR OR SPRAY WATER OVER THE

ENGINE OR MOTOR.

WARNING

Mix Volume

Cu. Ft.

3

4

6

9

Cement

(bags)

1/2

2/3

1

1-1/2

Water (gal.)

2-1/2

3-1/2

5-1/4 8

Sand (gal./

shovels)

9

12

18

18

Gravel (gal./

shovels)

12

16

23

23

NEVER PUT HANDS OR ANY OBJECT INTO

THE DRUM WHILE THE ENGINE OR MOTOR

IS RUNNING.

ALWAYS DISCONNECT THE SPARK PLUG

WIRE OR ELECTRIC CORD WHEN CLEANING

INSIDE DRUM.

TOWING

Before attempting to tow this mixer, check the state

and local laws that apply to your intended route and

check the following:

1. Hitch attached to the towing vehicle

securely.

2. Towpole fully extended and bolted to mixer

securely.

3. Safety chain hooked up properly (see

illustration below or decal on mixer front

post).

INSTALLING CHAIN TO VEHICLE

4. Lug nuts, wheel nuts and axle mount nuts

tight.

WARNING

65CMED & 95CMED