866-795-1586 • WWW.STONEAGETOOLS.COM
18
4” BADGER ASSEMBLY
ASSEMBLY
1. Grease the open side of the Bearing.
2. Note the orientation of the Bearing before
pressing it onto the Shaft. The greased side
should be down. Use an arbor press to
press the Bearing onto the Shaft. Be sure
the bearing is set flat on the press before
applying pressure. Pressing the shaft into the
bearing at an angle could cause damage to
the bearing.
3. Align the internal flats of an Inner Disc with
the flats of the Shaft and place over the Shaft.
4. Place an O-Ring on top of this Disc.
5. Place an Outer Disc on after the O-Ring.
The
external flats of the Outer Discs should be
aligned with the flats inside the head.
6. Repeat these steps until there are three Outer
Discs and four Inner Discs on the Shaft.
7. Push down on top disc and install the
Retaining Ring in the groove around the
Shaft.
BAE 001-
xx
Shaft
Figure 7: For Steps 1-2
BRLM 109
Bearing
BAE 017
Retaining Ring
BAE 015
Inner Disc (4)
BAE 016
Outer Disc (3)
BAE 010
O-Ring (3)
The Outer
Disc flats
will align
with the
flats inside
the head
Align Inner
Disc flats to
Shaft flats
GREASE
Figure 8: For Steps 3-7
GREASE
ANTI-SEIZE
= Chevron Multifak
®
EP1 Tan
= Swagelock
®
Blue Goop or
Equal
