866-795-1586 • WWW.STONEAGETOOLS.COM
27
BA 318
Pins (2)
BA 312
O-Ring
BA 340-RXX
Head
6” BADGER DISASSEMBLY
Figure 5: For Steps 9-10
6. Press the Bearing off of the Shaft Adjust
Sleeve.
7. There is no need to remove the Pins from
the Shaft; however, if they fall out do not lose
them.
8. If the Shaft Adjust Sleeve fails to remain in
the set position while the tool is in use, it
may be necessary to unscrew the Shaft from
the Shaft Adjust Sleeve in order to replace
the (2) O-Rings. Normally it is not necessary
to disassemble the Shaft from the Adjust
Sleeve.
Figure 6: For Steps 11-13
9. Remove the Shaft Seal and inspect for
damage.
10. Remove the Port Screw from the Nut.
BA 308
Shaft Seal
BA 307
Shaft Seal
BA 302
Nut
BJ 026
Port Plug
BJ 026
Port Plug
BA 303
Shaft Adjust
Sleeve
BA 310
O-Ring (2)
BA 309
Bearing
BA 318
Pins (2)
Figure 4: For Steps 6-8
BA 301-P8 or
BA 301-M9 or
BA 301-M24x1.5
Shaft
11. Remove the Port Screw from the Head.
12. Remove the Shaft Seal and O-Ring if they are
damaged.
13. There is no need to remove the Pins;
however, if they fall out, do not lose them.
