866-795-1586 • WWW.STONEAGETOOLS.COM
28
.380
Insert Pins just
far enough to
clear groove for
retaining ring
6” BADGER ASSEMBLY
ASSEMBLY
1. Press Bearing onto Shaft Adjust Sleeve.
2. Check that Pins are installed in Shaft.
3. Place an Inner Disc on Shaft, aligning with
pins.
4. Place an O-Ring on top of this Disc,
stretched around the pins.
5. Place an Outer Disc around the outside of
this O-Ring
6. Place another Inner Disc, and also place an
O-Ring around the outer edge of this Disc.
7. Repeat steps 3 through 6, until there are
four Outer Discs and five Inner Discs on
Shaft. Note that there is no outer O-Ring
on the Inner Discs at each end of the stack.
8. Push down on top disc and install the
Retaining Ring in the groove around Shaft.
Install Bearing on shaft.
BA 311
Bearing
CST 141
Retaining Ring
BA 315
Inner Disc (5)
BA 316
Outer Disc (4)
SM 116
O-Ring (4)
BJ 008
O-Ring (3)
Figure 8: For Step 3-8
BA 318
Pins (2)
BA 309
Bearing
BA 303
Shaft Adjust
Sleeve
Figure 7: For Steps 1-2
Align Notches
to Pins
GREASE
ANTI-SEIZE
= Chevron Multifak
®
EP1 Tan
= Swagelock
®
Blue Goop or
Equal
