13
866-795-1586 • WWW.SEWERNOZZLES.COM
ASSEMBLY
Figure 3 For Step 4
Figure 5: For Steps 7-9
Figure 4: For Steps 5-6
TECH TIPS:
Greasing the O-Ring
on the H.P. Seal
prevents it from
tearing in the tight
bore of the Shaft.
4. Slide Shaft (WT 001-XX) thru Shaft Seal in
Sleeve, thru both bearings (WT 007), and
install the Retaining Ring (WT 033) on shaft
above bearings. Make sure it seats well in
the groove in the shaft.
5. Install Wave Spring (WT 014) in bore of
Shaft. Apply grease to H.P. Seal O-Ring
(RJ 012-KTO) before sliding it into the bore
of the Shaft.
6. Apply grease to the flat face (the end with
the larger diameter) of the Seat (RJ 011-K)
and install into bore of shaft, on top of H.P.
seal. The grease should hold the seat in
place; if it falls out, apply more grease.
7. Slide shaft assembly into head. Install
Retaining Ring (WT 032) in groove of head.
Make sure it is fully inserted in the groove.
8. Install the O-Ring (WT 030) into the shallow
groove of the Shaft at the rear end of the
tool.
9. Refer to the Maintenance Section for
viscous fluid filling instructions before using
the tool.
WT 032
Retaining Ring
WT 030
O-Ring
WT 007
Bearings (2)
WT 007
Bearings (2)
WT 002
Shaft Seal Sleeve
RJ 011-K
Seat
RJ 012-KTO
H.P. Seal
WT 014
Wave Spring
WT 033
Retaining Ring
*WT 040-R24-C
(For WT-1/2 Only)
WT 040-R31-C
WT 040-R45-C
WT 040-R60-C
Head Options
(WT-3/8 Only)
WT 001-P6 or
WT 001-BSPP6
(WT-1/2 Only)
WT 001-P8 or
WT 001-BSPP8
Shaft Options
(WT-3/8 Only)
WT 001-P6 or
WT 001-BSPP6
(WT-1/2 Only)
WT 001-P8 or
WT 001-BSPP8
Shaft Options
