Connecting Antennas and Cables
11
C o n n e c t i n g A n t e n n a s a n d C a bl e s
Only some FW-105 Series appliances support wireless connections. If
your appliance does not have WLAN support, proceed to
Connecting the
Cables
below.
Connecting the Antennas
To connect the antennas
1.
Locate the two antennas included in the delivery.
2.
Install the antennas to the two connectors on the appliance’s
back panel (see
Back Panel
(page 10)) and tighten the knurled
nuts at the base of the antennas to secure them firmly to the
appliance.
3.
Orient the antennas.
Connecting the Cables
To connect network cables
1.
Connect network cables to the Ethernet ports.
•
The Ethernet ports are numbered 2-0 from left to right.
•
You are free to choose which Ethernet ports you connect to which
network. The Ethernet ports are mapped to Interface IDs during
the initial configuration.
•
If you intend to use the plug-and-play configuration method,
connect a cable at least to Ethernet port 0 that is used for
contacting the Stonesoft Installation Server.
2.
Connect the cable to the DSL port.
Note –
Standby power is supplied to the system even when the
appliance is turned off.
Power connector
(
Some models
) DSL port
Ethernet ports
