12
Connecting Antennas and Cables
•
The DSL port number is 4.
3.
(
Optional
) Connect a 3G modem to one of the USB ports.
•
The port number of the 3G modem is 0.
In appliances that have WLAN support, the port number of the
integrated wireless network card is 3.
Speed/Duplex Settings
Network cards at both ends of each cable must have identical speed/
duplex settings. This also applies to the automatic negotiation setting: if
one end of the cable is set to autonegotiate, the other end must also be
set to autonegotiate.
Connecting the Appliance to the Power Supply
To connect the appliance to the power supply
1.
Connect the power cable to the power connector on the front of
the appliance.
2.
Plug the power cord into a grounded, high-quality power strip that
offers protection from electrical noise and power surges.
•
We highly recommend using an uninterruptible power supply
(UPS) to ensure continuous operation and minimize the risk of
damage to the appliance in case of a sudden loss of power.
Note –
The ports and port numbers of the physical appliance must
match the interface definitions and Interface IDs that you have
defined for the firewall engine in the Stonesoft Management Client.
Note –
When the appliance is powered and you need to unplug it,
always wait at least ten (10) seconds before plugging in the appliance
again. Otherwise, the appliance may not have time to initialize itself
properly and fails to start.
