30
Configuring the Appliance
•
The typical setting for
Activate at boot
is
Yes
. If you set this
option to
No
, the interface is disabled until you change this
setting and then reboot or manually apply the boot-time
configuration on the main Network Interfaces page.
8.
Click
Create
to save the interface configuration without activating
it, or click
Create and Apply
to save and activate the interface
configuration.
•
The typical setting for
Activate at boot
is
Yes
. If you set this
option to
No
, the interface is disabled until you change this
setting and then reboot or manually apply the boot-time
configuration on the main Network Interfaces page.
Configuring Routing
To configure routing
1.
In the SSL VPN Web Console, under the
Networking
category in
the menu on the left, select
Network Configuration
.
2.
On the right, click
Routing and Gateways
. The Routing page
opens.
3.
Define the
Default Router
in one of the following ways:
•
Select
None (or from DHCP)
if the IP address of the default
gateway is dynamically assigned.
•
Select
Gateway
and enter the IP address of your gateway.
4.
Select the interface through which the gateway
Device
is reached.
5.
(
Optional
) Configure the following settings to define
Static Routes
through a next-hop gateway (such as a router), and/or
Local Routes
to devices that are connected directly (such as through a hub or
directly through a crossover cable):
•
Interface
: Enter the name of the interface used by the route.
•
Network
: Enter the IP address of the network to which the route
belongs.
