26
Chapter 4
Configuring NAT Addresses
3.
Right-click
Locations
and select
New Location
. The Location Properties dialog opens.
4.
Type in a
Name
.
5.
Select element(s).
6.
Click
Add
.
7.
Repeat steps 5-6 until all necessary elements are added.
8.
Click
OK
.
Repeat to add other Locations as necessary.
Adding SMC Server Contact Addresses
The Management Server and the Log Server can have more than one contact address for each
Location. This allows you, for example, to define a contact address for each Internet link in a
Multi-Link configuration for remotely managed components.
To define the Management Server and Log Server contact addresses
1.
Right-click a server and select
Properties
. The Properties dialog for that server opens.
What’s Next?
If your Management Server or Log Server needs a contact address configuration,
proceed to
Adding SMC Server Contact Addresses
If you plan to add contact addresses only for Sensor or Analyzer elements, proceed to
Defining Sensors and Analyzers
5
6
1
Summary of Contents for stonegate 5.2
