71
Installing the Engine in Expert Mode
4.
Check that the partition table information is correct.
5.
Select
Write
to commit the changes and confirm by typing
yes
.
6.
Select
Quit
and press E
NTER
.
Allocating Partitions
After partitioning the hard disk, the partitions are allocated for the StoneGate IPS engine.
To allocate the partitions
1.
Check that the partition table is correct. Type
yes
to continue.
2.
Using the partition numbers shown in the partition table, assign the partitions for the
engine, for example:
•
For the engine root A partition, type
1
.
•
For the engine root B partition, type
2
.
•
For the swap partition, type
5
.
•
For the data partition, type
6
.
•
For the spool partition, type
7
.
3.
Check the partition allocation and type
yes
to continue. The engine installation starts.
4.
When installation is complete, remove the CD-ROM from the machine and press E
NTER
to
reboot.
Swap
Logical
Linux swap
Twice the size
of physical
memory.
Swap partition for the
StoneGate IPS engine.
Data
Logical
Linux
500 MB or
more
Used for the boot
configuration files and the
root user’s home directory.
Spool
Logical
Linux
All remaining
free disk
space.
Used for spooling
Table 8.1 Partitions for the Engine (Continued)
Partition
Flags
Partition Type
Filesystem Type
Size
Description
What’s Next?
Continue the configuration as described in
Summary of Contents for stonegate 5.2
