24
Initial Configuration
Configuring the Network Interfaces
The configuration utility can automatically detect which network cards
are in use. You can also add interfaces manually, if necessary.
T
To add the network interfaces
Check that the automatically detected drivers are correct and that all
interfaces have been detected. To add interfaces manually, click
Add
and select a device driver.
T
To map the physical interfaces to interface IDs
Note –
The Management interface must be the same that you
configured as the Primary Control Interface for the corresponding
Firewall element in the Management Center.
Highlight
Next
and press E
NTER
to continue.
Highlight
Autodetect
and
press E
NTER
.
1. Type in the IDs to define how physical interfaces are mapped to the
Interface IDs you defined in the Firewall element. Ethernet ports are
detailed in
Illustration 10
in
Connecting the Cables
, on page 18.
3. Highlight the
Mgmt
column and press the spacebar on your
keyboard to select the correct interface for contact with the
Management Server.
2. Highlight the
Media
column and press E
NTER
to match the
speed/duplex settings to those used in each network. It is
recommended that you leave the speed/duplex settings to
Auto, so that they are negotiated automatically.
