5
GENERAL INSTRUCTIONS
Assembly is done with the rivets of the beams fitting into the slots of the posts. A rubber
mallet should be used on the beams to secure the rivets properly. A hammer can also
be used, providing one uses a cloth or block of wood between the hammer head and
the parts, to prevent damage. Tap gently and be sure the rivets are straight and fully
engaged.
WORKBENCH ASSEMBLY
STEP 1
Start bottom of frame assembly by joining a short double rivet beam (item 3) into the
two bottom keyholes of a corner post (item 1). Be sure that the flange is facing up, then
drive the rivets into the bottom of the key hole by hitting the beam with a rubber mallet.
Repeat this action with the second corner post (item 1), now creating one bottom end
section.
Tip:
Hit the beam close to joints, locking the pieces together.
