StorageWorks RAID Array 410, Installation Manual

Getting Started – RAID Array 410 for HP-UX

iv

EK–SMRA3-IG. C01

3.1.2.1

Select an Available Double-High Adapter Slot ..................................................... 3–3

3.1.2.2

Verify the Setting of the SCSI ID DIP Switches ................................................... 3–4

3.1.2.3

Insert the HP-PB Host Adapter in the Available Slot ............................................ 3–5

3.1.2.4

Connect Cable to Adapter Connector.................................................................... 3–6

3.2

Installing the Subsystem ............................................................................................. 3–7

4 Preparing HP-UX 9.04 for Use with the StorageWorks RAID Array

Controller

4.1

Installing the HP-UX Device Driver ........................................................................... 4–1

4.1.1

Determine the Interface Required................................................................................ 4–1

4.1.2

Verify the Availability of the Required Device Driver ................................................ 4–2

4.1.3

Create a disktab Entry................................................................................................. 4–3

4.1.4

Set the SCSI Bus Address of the RAID Array Controller............................................ 4–3

4.1.5

Reboot the System and Verify the Successful Installation ........................................... 4–3

4.1.6

What to Do Next ................................................................................................ ........ 4–4

Appendix A Configuration Records – Blank Forms

Figures

1–1

Minimum Installation Clearance Measurements.......................................................... 1–1

1–2

Unpacking the SWXRA–Yx ....................................................................................... 1–2

1–3

Installation of Ramp on Shipping Pallet...................................................................... 1–3

3–1

Adapter Faceplate LEDs ............................................................................................. 3–2

3–2

Rear View of HP9000 Series 800 Computer ............................................................... 3–3

3–3

Host Adapter Board .................................................................................................... 3–4

3–4

Host Adapter Board DIP Switches .............................................................................. 3–5

3–5

Inserting the Host Adapter Board................................................................................ 3–5

3–6

Back of Host Computer with Host Adapter Board Installed ........................................ 3–6

3–7

Host Adapter Board with Cable Attached ................................................................... 3–7