Chapter 5. Removal and Replacement
EK–MOL80–SV. B01
5–35
Reassembly:
When replacing the rear rope tensioner be sure that the tensioner `spring' area is
positioned in such a way that it is facing you. This will insure that the rope ten-
sioner is in the right position to fasten to the translate frame. To give yourself
enough rope slack, fasten the drive rope ends to the rope tensioner *before*
hanging the drive rope over the top two pulleys.
Before applying tension by setting the rope tensioners, insert the ropes into the
rope coupler and attach the coupler cover plate.
Figure 5–42 Positioning the Tensioner to Mount on Translate Frame
Replacing the Controller PCA
1.
Follow the steps in the service access procedure at the beginning of this
chapter to remove the rear access panel.
2.
Remove the seven T-20 screws on the controller PCA cover. Note the two
reference pin holes on the rear edge of the cover.
