6
Introduction
StorCase Technology, Inc.
SATA-to-USB 2.0 DE110 User's Guide - Rev. A00
Figure 5A: Receiving Frame Motherboard
(Rear View)
Receiving Frame Rear Panel
(Figures 5A & 5B)
USB Connector
-
Provides a standard interface for USB 2.0 signals.
DC Power Connector (P1) -
A standard 4-pin DC power connector is used to accept
DC power.
Option Pins (W1)
- Refer to Figure 5B.
ID0 & ID1
- Jumper is factory-installed on ID0. Change jumper position to Pins 3 & 4 for
ID1 designation.
ID0 & ID1 are for ID display purposes only.
Refer to Table 1 for further
information.
Remote Activity LED (RLED)
- For PATA drives, these pins provide power for a remote
LED device activity indicator (Pin 13=Cathode, Pin 14=Anode).
Factory Reserved Pins -
These pins are reserved for factory use only - Do not install
jumper under any circumstances!
USB 2.0
Connector
Option Pin
Connector
Factory Reserved Pins
(No Jumper Installed)
DC Power
Connector
All manuals and user guides at all-guides.com