137
Stříkání
Nastavení vzhledu nástřiku
1. Pistoli ve vzdálenosti cca 150 - 200 mm držte kolmo k
povrchu.
2. Pohybujte stříkací pistolí, dříve než stisknete spoušť.
Pistoli veďte rovně a rovnoměrně. Na konci pohybu povol-
te spoušť.
3. Regulace množství materiálu a vzduchu
Čím dále zatáhnete za spoušť směrem dozadu, tím vyšší
je množství materiálu a vzduchu.
Správně
Chybně
Čištění stříkací pistole
1.Odlehčete tlak.
2. Závěsnou nádobku odejměte a vyprázdněte materiál
ke stříkání.
3. Naplňte kompatibilním rozpouštědlem.
4. Závěsnou nádobku opět připojte.
5. Pistolí zatřepejte.
6. Turbínu připojte k pistoli a zapněte, rozpouštěd-
la vystříkejte a postup opakujte až stříká ven čisté roz-
pouštědlo. Dbejte na odbornou likvidaci spotřebovaného
rozpouštědla.
7. Závěsnou nádobku odejměte. Odstraňte zbylé roz-
pouštědlo příp. vodu ze závěsné nádobky.
8. Závěsnou nádobku zevnitř očistěte čistým hadříkem.
9. Sundejte zajišťovací kroužek, vzduchový kryt a trysku
na materiál. Očistěte je v kompatibilním rozpouštědle.
Vnější plochu pistole očistěte hadříkem, který byl navl-
hčen kompatibilním rozpouštědlem.
10. Pistoli smontujte.
2
3
4
5
8
9
10
Summary of Contents for HVLP SmartFinish
