charging Process
Connect the power cable to the supplied charger
(a)
. Put the mains
plug into a 220V socket. A red LED lights up and another red LED blinks
at the charger, i.e. the charger is ready for the charging process.
Put the charging plug into the charging socket on the right side of the
rechargeable battery
(b)
. The second LED lights up red on the charger,
i.e. the rechargeable battery is properly connected and the charging
process has started.
You can check the current state of charge during the charging process
by pressing the check button
(c)
on the rechargeable battery. One to
five LEDs on the rechargeable battery will light up.
When the second LED on the charger will light up green, the charg-
ing process is complete. Pull the charging plug out of the rechargeable
battery. Pull the mains plug out of the socket and disconnect the mains
cable from the charger.
A
A complete charging process takes five to eight hours. A
rechargeable battery with a bigger charging capacity may
even take longer.
i
For more information about the rechargeable battery in-
cluding technical specifications read the label of the battery
charger as well as chapter “Technical Specifications”.
mounting the battery
Place the rechargeable battery on the mounting device
(d)
at the frame
and move it slightly upwards until the guide lugs of the battery shell
slide into the grooves of the mounting device. Subsequently, slide it
downwards until the plug contacts fit snugly. Finish by turning the key
clockwise.
a
Always make sure you have pulled out the key before you set
off!
20
a
b c
d