Stage 1.
Secure the seat base to side panel at 380mm
from end of post to bottom of seat support.
Use 2 x 70mm screws.
Ensure that top rafter is facing outside of
assembly.
Fix second side panel in similar manner.
Use 2 x 70mm screws.
Stage 2.
Stand arbour upright and fix seat back into
angled slots provided in seat base support.
Use 1 x 70mm screw for each side of seat
back.
Use 2 x 25mm screws for each side to secure
seat back into angled joint with seat base.
Stage 3.
Fix horizontal top back support to post,
35mm down from top of side panels, using
2 x 50mm screws.
Fix angled braces into post and inside surface
of back support using 4 x 50mm screws.
