Assembly Guide
Sloped Shelf
Shelving
Hardware
Set-up
Overall Dimensions
All required hardware is included.
Please check the contents with your
packing slip.
Read instructions carefully.
Save this document for future reference.
Two people are required for the assembly.
The sloped shelves must not be used
with shelving over 99" in height or with
mezzanines.
Tools Required
Outils requis
7/16"
Phillips #3
Chalk line
1/4-20 bolts
7/16"
1/4-20 bolts
5/8"
1/4-20 bolts
1"
1/4-20 nuts
Nylon clip
Check the leveling of the floor in order to
determine the critical areas. Us
e
floor
anchor plates and
shim
plates to level
the shelving units.
Make sure that no obstacle nor electrical
wiring comes in contact with the
structure.
R
ecommendation:
Plumbness:
The shelving must be installed with a
maximum tolerance from the vertical of
1/2" inch in 10 feet of height.
Floor plates must be anchored if more
than one shim is used.
Nominal
width
+ 1 5/8"
30", 36", 42", 48"
Nominal widths
1/16''
A
with back braces
It is recommended to lay out shelving
positions on the floor with a chalkline
before beginning the installation.
B*
nominal dimension
real dim.
18", 24"
30, 36"
A
nominal
+ 1/4"
nominal
+ 1/2"
nominal
+ 9/16"
nominal
+ 9/16"
with back braces
with back panels
24"
30"
36"
48"
B *
Depths
1 5/8"
Some of the illustrated hardware is only supplied with optional components.
S
him
1/4-20 bolts
1x
5/8"
1/4-20 nuts
1x
Anchor
Plate
Cut-resistent gloves
3DJH
www.StoreMoreStore.com | 855-786-7667
