Engineering Manual for
AXS Series S60 Keypads
S60 Engineering Manual
Page 12 of 12
Rev 1.6 May 2016
© Copyright Storm Interface. 2016. All rights reserved
Regulatory Information
This device complies with Part 15 of the FCC Rules and Industry Canada licence exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
F.A.Q’s
Q: The illumination on my S60 is not steady : it flickers noticeably.
A : Powering the S60 via long ( > 30m) cable lengths can lead to flicker on the keypad and backlight illumination
This is because the cable resistance causes voltage drops which are modulated by the HID module scanning
for a card
You can mitigate the flickering as follows:
1) Use lower resistance cable
2) Parallel wire two cables for the +12V connection and two cables for the Ground connection
3) Provide power locally to the S60
4) Switch off the blue backlight illumination’
